Duet 3 HC6 one final try before i give up.

Snippy

Allso is it possible to update 3.1.1 to 3.2 from webcontroll?
Since the update via usb takes around 4 hours to get the board out of its hideyhole and dont have a laptop to avoid ground loops.

Veti

@Snippy said in Duet 3 HC6 one final try before i give up.:

Allso is it possible to update 3.1.1 to 3.2 from webcontroll?

yes

see
https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware#Section_Usual_procedure

but since you did the update to 3.1.1 not via web interface you might be missing the 3.0 files.

Snippy

@Nuramori Never had any print quality issues, if it desides to load the gcode.

Its a cartesian system.

Snippy

@Veti
O lord have mercy.

fcwilt

@Snippy

Hi,

Sorry to hear you are having problems.

Could you provide me with brief list of the things that are not working for you?

I have a MBH6C board on my workbench at the moment and it is working fine. It's very likely I can get yours working for you as well.

I have printers running both 3.1.1 and 3.2.

Frederick

jrockland

@Snippy I just copi/pasted from the reprap gcode page, about how to use m552

Snippy

WOW... the webcontroll update from 3.1.1 to 3.2 worked without a sacrifice.

fcwilt

@Snippy said in Duet 3 HC6 one final try before i give up.:

WOW... the webcontroll update from 3.1.1 to 3.2 worked without a sacrifice.

Just so you know 3.2 has issues of it's own that occur in certain configurations that are somewhat uncommon.

Frederick

Snippy

@fcwilt was not supriced

Snippy

Well the update seems to have increased the upload speed significantly.

Snippy

allso now my independent twin print cooling systems seems to work.