Enstop + bltouch

Amagatth

@jay_s_uk thx for the answer I can use my bl to the mesch with the 4 endstop?

jay_s_uk

see here https://duet3d.dozuki.com/Wiki/Bed_levelling_using_multiple_independent_Z_motors

Amagatth

@jay_s_uk I understand the process and I have already see this page but I don't see any information about 4 endstop for the level of my "screws" and the bl touch for the bed

Sry for my English ^^

jay_s_uk

well you basically set your screw/pivot point location using M671
then edit the bed.g file to set the 4 probe points

G28 ; home
G30 P0 X0 Y0 Z-99999 ; probe near a leadscrew
G30 P1 X0 Y0 Z-99999 ; probe near a leadscrew
G30 P2 X0 Y0 Z-99999 ; probe near a leadscrew
G30 P3 X0 Y0 Z-99999 S4; probe near a leadscrew and calibrate 4 motors

Adjust the probe points to get them as close as you can to the 4 screws.

Both the M671, M584 and the probe points above need to be in the same order. e.g. front left, front right, back left, back right.

Amagatth

@jay_s_uk I try to make this fonction but it's not perfect it's why I ask for 4 endstop for screw and the bl for the bed

jay_s_uk

@Amagatth why is it not perfect?
both my machines that have independent levelling utilise G32 and neither of them have any endstops on Z

Amagatth

I don't see modification after g32

jay_s_uk

None at all?

Post your full config, homeall, homez, bed and a photo of your machine would be good

Amagatth

I send you all tomorrow thx

Amagatth

Hi ,

You can find my configuration and bed file, on the photo at front left its Z1 back left Z2 front right Z3 back right Z4

THx for your help

bed.g config.g homez (1).g homeall (1).g

Correction when i make g32 i see screw moove at the end but the mouvement is not good my X axis isn't parallel with my bed

jay_s_uk

its advised not to have half the drivers for an axis on one board and half on the other.
The best thing to do would be move the extruders on to the expansion board and have all 4 z motors on the main board.

Is your bed fully rigid and only adjusted in height by the motors? If so, your M671 coordinates are wrong. Its perfectly acceptable to have locations that are outside the machine limits. e.g. X-100:-100:1100:1100.

You don't have any offsets set for your bltouch in G31

In your homez, I suggest probing the centre of the bed rather than at X15 Y15. You should take into account any probe offsets when inputting the location. This comment also applied to homeall

You should not be calling M401 and M402 as part of the bed file. They are automatically called by probe type P9.

Everything else looks ok

Amagatth

I already change zhome on center and my bed is fix just the 4 motor move my x/y axis up or down

The coordinate of motor are z1 x-50 y0 z2 x-50 y 1000 z3 x1050 y0 z4 x1050 y1000

Amagatth

i have change m671 with real screw coordinates and its look better ! thx !!