Duet Maestro Z-Home moves X&Y axis.
-
The high jerk has not been a problem in the past (last week on the printer next to it), will try tomorrow.
Still not getting any Z-movement.
Il do the update tomorrow, to see if there is a change in reporting.
If this does not work Il pull the maestro from the printer that is now decommissioned, need to start printing enclosures.
-
what voltage are you running at?
if its 12v then that will be your problem because you are using the second z connector.
-
24v, have a separate supply 12V for fans and a peltier element.
-
Updated the firmware, no change in the error message.
Reduced the M566 and M203 settings, no change. -
try seperating the z motors anyway.
connect the second z motor to e1
see
https://duet3d.dozuki.com/Wiki/Bed_levelling_using_multiple_independent_Z_motorsyou gain bed leveling as well.
-
Had extension cables on the Z motors, took those out (taking these cables to there limit...) and now it works.
After the 2.05.1 update my XY movement is weird(xy-homing only moves 1 motor) but ill figure it out, thanks for you guy's attention! -
post your homing script.
if you created them without selecting corexy first. they may contain h2 movements for x and y which cause that.
-
TBH I don't know what it was, changed the motor orientations a couple of times and eventually came back to what I had and it worked. Now it's printing happily on the maximum speed I can extrude ~130mm/s, 300mm/s looked really cool until the extruder couldn't keep up...
-
what hotend are you using?
-
Mahor.xyz V3 pellet extruder.
