PT100 on Duet 3 6hc
-
Hello dears,
a very basic question, is it possible to connect a pt100 temperature sensor on a duet 3 6hc board without using a temperature daughter boards?
Thank you very much and greetings!
-
@Nino-Nobile no, hence why they sell daughterboards
-
@Nino-Nobile said in PT100 on Duet 3 6hc:
Hello dears,
a very basic question, is it possible to connect a pt100 temperature sensor on a duet 3 6hc board without using a temperature daughter boards?
Thank you very much and greetings!
It's possible, but the resolution and accuracy would be very poor.
-
you can use a pt1000 without the daughter board.
they work very well -
@dc42 Thank you very much for your reply! Yes, I think it would have 1 ohm every 5ºC approximately, anyway I am interested in doing a test until deciding whether to buy a dougther board or maybe a pt1000. Is there information on what are the coefficients with which I must configure the firmware?
-
Just get a Pt1000
-
@Veti Yes, the problema alredy buy a pt100
-
In that case, buy a daughterboard.
-
you can get a pt1000 sensor for around 4 euros.
-
Okok I understand the point, I think it will be easier and faster to get a pt1000 than a dougther board (I'm in Argentina). Thank you very much to all!
-
there is a e3d reseller in argentina.
https://www.printalot.com.ar/you can see if they sell
https://e3d-online.com/products/pt1000-temperature-sensor?_pos=1&_sid=1e8da88ec&_ss=r
its a bit more expensive, but if speed is the issue.