FANS.... CONFUSION
-
I have two separate extruders, they are water-cooled so I do not need any cooling fans configured nor need any thermostatic control
Hot end 0 has heater 0, Tool 0, Drive 0, heater 1 and Fan 0
Hot end 1 has heater 1, Tool 1, Drive 1, heater 2 and Fan 1no thermostatically controlled fans
in my config I have ....
M563 P0 S"EXTRUDER 0" D0 H1 F0 ;TOOL 0 USES DRIVE 0 AND HEATER 1
G10 P0 S0 R0 X-16.5 Y0 ; set tool 0 axis offsets
M563 P1 S"EXTRUDER 1" D1 H2 F1 ; define tool 1
G10 P1 S0 R0 X16.5 Y0 ; set tool 1 axis offsetsM950 F0 C"fan0" Q500 ; create fan 0 on pin fan0 and set its frequency
M106 P0 S0 H-1 ; set fan 0 value. Thermostatic control is turned off
M950 F1 C"fan1" Q500 ; create fan 1 on pin fan1 and set its frequency
M106 P1 S1 H-1 ; set fan 1 value. Thermostatic control is turned offwhen I switch the machine, Fan 2 switches on (status at power on is switched on- I do not want this.
What I want to achieve is that I have two different PART COOLER FANS which I want to run by command independently.
Thanks for any help.... It complicated...
-
Hi,
On your second M106 P1 S1 that S1 specifies full speed - change it to S0 and the fan will be off at power on.
Frederick
-
Many thanks...
That sorted it.