Smart effector duet 0.85 wiring

Gaou

Guys i need some help wiring these two. I am a little confused and i dont want to s***** any of them.

My main problem is that i cannot understand the thermistor and the probe connection ot the duet. So i have the pt1000 but onnthe 8 pin molex connection there are 4 pins were supposed to be connected to the probe on the board and four more pins labelled as t1 t2 etc.

If i plug there one of my pt1000 cable the other one shoul go to any negative ive on the board?? If so that means that the probe and the thermistor shoud have a common negative ?

Coming to the probe. All of the four pins of the 0.85 should connected to the four of the effector. I am getting the positive 3,3v and the negative but i am not sure of the wiring of the remaining two pins.

Any help would much appreciated...

Gaou

My main problem is that i cannot understand the thermistor and the probe connection ot the duet. So i have the pt1000 but onnthe 8 pin molex connection there are 4 pins were supposed to be connected to the probe on the board and four more pins labelled as t1 t2 etc.

~~If i plug there one of my pt1000 cable the other one shoul go to any negative ive on the board?? If so that means that the probe and the thermistor shoud have a common negative ?~~
my mistake guys . i took the multimeter and read the guide and solve them all.

Coming to the probe. All of the four pins of the 0.85 should connected to the four of the effector. I am getting the positive 3,3v and the negative but i am not sure of the wiring of the remaining two pins.
The one pin is for sensitivity settings if i am getting this right and the other one is the signal . But which is which

Any help would much appreciated...

Phaedrux

@gaou said in Smart effector duet 0.85 wiring:

But which is which

Have you seen this?

https://duet3d.dozuki.com/Wiki/Smart_effector_and_carriage_adapters_for_delta_printer#Section_Connectors_and_Wiring

Gaou

@phaedrux said in Smart effector duet 0.85 wiring:

@gaou said in Smart effector duet 0.85 wiring:

But which is which

Have you seen this?

https://duet3d.dozuki.com/Wiki/Smart_effector_and_carriage_adapters_for_delta_printer#Section_Connectors_and_Wiring

thanks mate for posting

yeap i ve seen this . that was my guide . i just had to read it more than 10 times..... finally i got everyting set up and working as they should . i just couldn't find the pinout diagrams for the 0.85....

now i am waiting for my rods to test the effector in reality . it seems as a pretty good toy ...

Phaedrux

Pop back in if you have any other questions.