Incomprehensible problem
-
thank you for your reply,
Not the value is +1.50.
I am forced to go up the buzzard so it's much more I think. -
do you have a Z Probe?
If so what type is it? -
Yes I have a BL TOUCH
-
I believe the offset is only applied during the probing calculation, so you need to do another calibration before the offset is actually applied to the max print height.
-
The value for Z in the G31 line needs to equal the hight of the nozzle above the bed when the BLtouch triggers.
-
If my BL Touch is too high this can be a problem?
-
Well I'm really fooling with this machine,
It's been 3 whole days now that I try to do something with it but without success,
I think I will leave it aside and continue with my BLACK WIDOW that works really well,
One last question before I go through the window: what distance do you put between the BL TOUCH when the probe is in and the nozzle?
Is there a risk in making an update of the DUET WIFI,
Thank you for your patient -
If my BL Touch is too high this can be a problem?
Yes, it could be so high that it doesn't trigger before the nozzle hits the bed.
With any Z probe, you should always test it, measure it's trigger height and put that value in the G31 command in config.g before you try to use it for homing of bed probing.
-
Hello,
I'm still looking for my calibration problem.
I do not know what is wrong,
So here is the method that I practice,
1 - I lower my head until I catch a sheet on the board,
2- I then make a G92 Z0
3- I raise the head to about 50mm
4- I release the BL TOUCH
5- I lower the head until the BL TOUCH goes up and lights up
6- I open my config file and change the value here;
Z probe and compensation definition
; *** If you have a switch instead of an IR probe, change P1 to P4 in the following M558 command
M558 P1 X0 Y0 Z0; Z probe is an IR probe and is not used for homing any axes
G31 X0 Y0 Z1.65 P500; Set the zprobe height and threshold (put your own values here),And when the machine restarts I make G1 Z0 F1500 and the head come to sink a big blow in the plate,
What am I doing wrong?
Thank you -
for a start you have your config set for a IR Probe and not a BLtouch there is a thread on here about how to use a BL Touch.
-
I created a mount for my BLTouch that's connected to my Duet WiFi and included a number of Duet WiFi configuration/script files. It works good and you should be able to use them for a reference and the macro files to run your BLTouch.
https://www.thingiverse.com/thing:2389034
John
-
Thank you for your answers, I'll look at it later; I have to look at another problem "I really have no luck with this machine"
I miss the update of the DUET WIFI
