BLTouch question: "Alarm mode"
-
I was messing around with bed leveling and at one point had the nozzle fairly close, due to issuing a G30 S-1 command to see what the offset was. I forgot how close it was and commanded another probe, so the BLTouch was unable to extend its probe to full length, and it started flashing red.
No problem, I knew what caused it, but then was puzzled how to make it stop flashing. It ignored new commands, and I ended up having to cycle printer power. Is there any other way to reset it?
-
@kb58 one for you macro list reset bltouch M280 P0 S160
then rehome which should drop the bed 5mm or so before the probe. -
@peter247 Thank you sir, another one to add to the list!
-
https://github.com/Duet3D/RRF-machine-config-files/tree/master/DBotCoreXY/x0r-wifi-RRF3/macros
You might find some good examples in there as well.
