Duet3 6MB U Axis Homing
-
@neo0204 your config looks good after a quick look. Can you see what is reported with M119 when the endstop is not triggered, and then again when it is.
-
I think the challenge is here, it senses the end-stop is always at Home.
I have tried connecting the end-stop to other IO pins but the results were similar.
-
@neo0204 try swapping the endstop with the X stop - the stop is probably faulty if it is identical to the others you use and its always showing as stopped
-
@t3p3tony This is what I did as the first hardware debug, Swap the X-axis and U-axis end-stop, and X homed but U has a similar response.
-
-
@neo0204 also do you get any errors when you run your config.g using M98 P"0:/sys/config.g"
-
The challenge is not resolved even when connecting to other IO ports.
M98 P"0:/sys/config.g" commands shows below response.
-
@neo0204 which other port did you try?
-
@t3p3tony Thank you for helping debug this.
It is working now, the issue was with the end-stop extender wire.
Apologies for the inconvenience.
-
@neo0204 glad you got it fixed
