Destroyed my frimware

windiesel

didnt work
i didnt had the folder www so I made one and unpakt DuetWebControl. Then I put DuetWIFIServer into /sys.
After I put the card back in I turned the power back on and typed M997 S1 on the pannel due and got
Error: instalation failed due to comm write error
so I tryed by conecting the Due via USB to my laptop an send the comand with repetier and got the same error.

by the way I can reach the Printer via WIFI but the Webcontrol cant conect to the Printer
I tryed to rested it ones so i still have Web Interface Version: 1.12-RC1

I am still running 1.19beta11

Is there a way to set new Z hight via G- code cant find a comand

dc42

After sending M997 S1, did you get any progress messages on PanelDue prior to the "comm write error" one?

windiesel

it tryed to conect with different baudrates but all faild

dc42

@windiesel:

it tryed to conect with different baudrates but all faild

Try it a few more times, with just USB power applied, and also with VIN power applied. If it always fails to connect at all the baud rates it tries, ask your supplier to repair or replace the Duet.

windiesel

so frimeware update killed the DUET ?
is there a way to get a clean SD card image? something like all files you ship the sd card with.

by the way I bought the DUET here.

T3P3Tony

The firmware update won't have killed the Duet however something else is going on.

Can you confirm

With nothing plugged in other than the USB cable you can connect to the Duet over USB using pronterface/Repetier?
What happends when you send M997 S1 when connected over USB

windiesel

I do print with repetier host at the moment
when only Powerd by USB I typed M997 S1 via Paneldue got the error massage "Error: instalation failed due to comm write error" on the paneldue
when I conect whit repetier host I first get ERROR : Failed to initialise WIFI module code -10
then typed M997 S1 and got back "Error: instalation failed due to comm write error". it starts at Baud 460800 then 230400 -> 115200 -> 74880
with 5 V and 24V enable and no USB i got the same play

T3P3Tony

Try it without the panel due plugged in please

windiesel

same

dc42

What revision PCB is it: 1.0, 1.01 or 1.02; and when did you buy it?

windiesel

I think it is 1.0
I bought it late last year