Error on initial setup of Duet2 Ethernet, Duex5 and Paneldue 5i
-
I recently purchased Duet2 Ethernet, Duex5 and Paneldue 5i from Digitmakers in Canada for a custom Railcore build I have been working on. I have all the parts needed for the build so I decided to follow the instructions provided by Duet3D for the initial setup of the board(s). I plugged the Paneldue, and Duex5 into the Duet2 Ethernet then plugged the Duet2 into my PC to check that is recognized and to verify which version of firmware the board came with. I get errors regarding heaters in both the web interface and via terminal. These are only connect to my PC and all headers on the controllers are empty (no heaters, motors, powersupply etc). Can someone verify if this is an indication of bad hardware in need of replacement please.
Below is a screenshot of the errors that display on the Paneldue screen:
-
@tsd pretty sure that's all normal, first is warning that the heater could reach a high temp if a fault occurs and the thermistor not being attached is an open circuit.
Follow my adventures in 3D Printing, laser cutting and electronics. https://linktr.ee/Rushmere3D
-
@rushmere3d
Thanks for the info... I didn't want to mount these into the printer if they had issues and needed replacing.
