min. Temperature setting of the nozzle is too high
-
Hello all,
I am using a Duet2 wifi board. I got a filament that processes in the 120 - 150 °C range. Unfortunately, the current firmware cannot do this. Is it possible to change the min. value? Thank you very much for your help.
Greetings Maerkler -
@markler
If you mean the preset values in DWC and/or PanelDue, both can be configured in the settings.
Put whatever values you want in there.
You can also send whatever temp you want in your gcode
The slicer would normally add this. -
@markler you want to look at M302
https://duet3d.dozuki.com/Wiki/M302
You can set the lowest extrude temperature (160C by deg), or just allow cold extrusion
-
Many thanks OwenD and engikeneer , yes the M302 command was the one I was looking for. Thanks
