How offset (0,0) from endstop
-
Hi,
I've been looking at the wiki and I haven't seen anything....
My printer uses 2 endstops, 1 for the x-axis, and another for the y-axis, at the 0 coordinate. Still mechanically adjusting the endstop, these are very much at the limit of the silicone pad...
There is some way to tell you an offset from the endstop, for point 0? (Tell him that the endstop is at x-5 and y-5)
-
When you use a G1 H1 move to home an axis the movement stops when the endstop is activated and the logical position of that axis is set to the min or max value defined by the M208 settings for that axis.
So if the endstop for, say, the X axis, actually triggers at X = -5 then you could set the X axis min value in the M208 to -5.
Frederick
-
@fcwilt thx
-
