Filament runout only for active tool

[taconite]

Hey guys,

Is there a way to assign an filament run-out sensor to a specific tool. Reason is that I get filament run-out error even if the tool is not used in the current print.

Thanks guys

[chrishamm]

@taconite You can enable and disable the corresponding filament sensors in your tfree/tpost.g files using M591 Dnnn S0/S1. See https://duet3d.dozuki.com/Wiki/M591#Section_M591_RepRapFirmware_3_x. tfree*.g is executed when the current tool is deselected and tpost*.g is executed when a tool has been selected.