Delta printer based on Duet2WiFi refused to print

Dan 0

I build from scratch a delta printer as per the original (2015) design of @dc42.
I use the following configuration:
Board: Duet 2 WiFi (2WiFi)
Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.3 (2021-06-15)
Duet WiFi Server Version: 1.26
Smart Effector v2.0 +E3D-V6
PanelDue v3.0

I am stuck on putting it to work. I’ve already performed the delta calibration, mesh compensation, bed heater tuning. Extruder is working (when I put machine to extrude some filament)
I try to print something but even the arms were moving, nothing is printed. For me it is clear that something is wrong but I can’t figure out what. Please help me!

droftarts

@dan-0 Most likely a slicing issue. What slicer are you using? Does the extruder heat up to temperature?

Post the gcode file so we can see what it is doing at the beginning of the print. Also post your config.g.

Ian

Dan 0

@droftarts I used Slic3R v1.3.0. Ive also tried to print the files from duet package (Escher Lizard) which is also sliced with Slic3r v 1.1.7. Sme result - nothing

Dan 0

@droftarts
config.g
EscherLizard.gcode
Chamfered_thick-base_Escher_lizard 150 (1).gcode

Dan 0

@droftarts the heater is at 205 degrees and the nozzle is 0.4mm

droftarts

@dan-0 Can you send M98 P"config.g" and post the response? Also post your config-override.g (as you have M501 in config.g).

Ian

Dan 0

@droftarts
M98 P"config.g"
HTTP is enabled on port 80
FTP is disabled
TELNET is disabled
Warning: Heater 0 appears to be over-powered. If left on at full power, its temperature is predicted to reach 1156C

config.g
config-override.g