Lower case axises visible but not working 3.4RC2

[chrishamm]

@xtarr I put up DWC test builds for SBC and standalone mode on https://pkg.duet3d.com/testing

[dc42]

@xtarr you should also use RRF 3.4.0rc2+2 available at https://www.dropbox.com/sh/amtiizdcylnuaye/AAA4hzXFvU0RMOSDtdT37HFua?dl=0.

[xtarr]

@dc42 I am running into the same issue even though I am running 3.4RC2+2. All of the axises but the j and k work.

[dc42]

@xtarr how are you trying to move the j and k axes now? Are you running the updated DWC as well?

[xtarr]

@dc42 I am trying to run it through the Duet Web control dashboard. I updated the firmware but not the DWC. How would I go about that?

[xtarr]

@dc42 I didn't see the duet web control package in the dropbox link you sent.

[jay_s_uk]

@xtarr they're here https://pkg.duet3d.com/testing

[xtarr]

@dc42 The motions for the lower case axises do work through gcode command line

[xtarr]

@jay_s_uk I am running the DWC firmware for 3.4RC2 but I am looking for DWC 3.4RC2+2

[jay_s_uk]

@xtarr its in the link I gave you

[xtarr]

@jay_s_uk I am very sorry. You are right. Just added this and everything works now. Thank you!