power cut

oliof

@sgk My bet is you have a G29 S1 early on in your config.g. If this is a RatRig V-Core machine, that was an error in their example config. Either remove that line or -- if it is the V-Core config -- change it to G21.

A Former User

@oliof hello tank you for help look my config i no have the g29config.txt

oliof

@sgk you are loading config-override.g at the end of config.g -- please share that as well. It would probably be fine to remove the M500 to avoid rewriting config-override.g everytime the machine boots.

A Former User

@oliof config-override.g

A Former User

@oliof said in power cut:

I must put at the end of config.goading config-override.g at the end of config.g

A Former User

@oliof like that config.txt

oliof

@sgk I see now this happens after you issue M916 ... you may need to look at /sys/resurrect.g and /sys/resurrect-prologue.g

The message is a warning, and since you may not be able to probe Z when doing power loss recovery, since the bed has a (partial) print which may interfere with probing Z

A Former User

this my resurrect-prologueresurrect-prologue.g

oliof

@sgk so yeah, the warning is because you cannot probe Z since a print is on the bed. I think you got to live with it after power failure unless you have a fail-safe way to probe Z0 with a full bed, which usually is not the case.

A Former User

@oliof ok thank you for or help