NO return log in YAT, Cannot Connect to DWC.
-
Hello Everyone,
I have a duet 2 wifi board I want to get connected to. I have done it before on a different duet 2 motherboard.
My problem is that I am connecting by USB and connecting to the YAT terminal.
But if I type commands, I don't get any response! M115, M552, It says sending, then nothing(sent) , but no response code.therefore. I cannot see what the wifi settings are in order to change them and connect to DWC.
Please help!
Thank you -
It sounds like the Duet doesn't have firmware installed. What LEDs are lit on the board? Does it show up in Device Manager?
You can also follow this guide to see how far you can get. It may help you resolve it.
https://docs.duet3d.com/en/User_manual/Troubleshooting/Duet_wont_respond
-
@phaedrux
I have a couple of the duet 2 boards and updated those with little issue. I have tired to use all the same code as the working motherboards.This board will connect to YAT and seems to respond to my commands via lights. turning on or off the wifi.
But i cannot see any return notes from the motherboard.
These lights are on while connected to yat
-
What does YAT report when you connect?
If there is no firmware installed it won't respond to anything because it has no brain to recognize commands.
What does it show up as in device manager?
Does it show up as a Bossa port?
Did you try the Bossa firmware flash steps? That would be my next recommendation.
