Magnetic filament monitor no data
-
I am trying to get the magnetic filament sensor to work. After updating to 2.05.1 I just get:
Duet3D magnetic filament monitor on input 3, enabled, sensitivity 24.80mm/rev, allow 70% to 130%, check every 10.0mm, no data received.
Cables are fine all is rotating when filament is pulled but no data? Only one green flash after switch on. Any suggestions? -
@empiricus I believe data is only received during a print, so give it a go
-
@jay_s_uk Yes that is during print. No data received.
-
How do you have it configured?
https://docs.duet3d.com/User_manual/Connecting_hardware/Sensors_filament
Why stop at 2.05?
@empiricus said in Magnetic filament monitor no data:
Cables are fine
How did you determine that?
