Time/ Date setting

[hauschka]

Hi,
I'm using the Duet3 in an SBC config.

I'm trying to set the time/date, via the M905 command.
when querying the printer about the time/date straight afterwards, it still thinks it's in 2020.

Any ideas on how to solve this?

[hauschka]

This is the current firmware that's on the device:

Board: Duet 3 MB6HC (MB6HC)
DSF Version: 3.1.1
Firmware: RepRapFirmware for Duet 3 MB6HC 3.1.1 (2020-05-19b2)

I understand there are updates available, however we're aiming to keep this device at that firmware for compatibility with a deployed device

Any ideas?

[jay_s_uk]

@hauschka SBC mode in 3.1.1 wasn't great duw processing stuff out of sync etc. If I were you I wouldn't bother as this won't be the only issue you have