End stops

[surrfman]

Working on acquiring electronics for use with 6HC board. Looking at end stops, can I use the mechanicals from donor N2 Plus, or best to change to electronic?

Thanks in advance, everyone has been extremely helpful.

[Phaedrux]

Photo of the endstops? Whatever they are, they can likely be reused no problem.

You may find some helpful info here: https://docs.duet3d.com/en/User_manual/Connecting_hardware/Sensors_endstops

[surrfman]

Thanks, documentation sez can use about anything. Image of a Raise microswitch end stop.

[Phaedrux]

That looks like a pretty plain microswitch. I can't tell from the photo if it's wired normally open or normally closed, but if you follow that linked document you should have no trouble using those.