How to read a hieight map
-
Got an ir probe Yesterday. Ran G29 after setting up everything and did some tweaks to get more constant bed level around the corners. This is my end result. Is this good other than that one corner. Or did I do something wrong?
-
Is this a better way to tell
-
Can you post a photo of what your actual bed surface looks like?
The average difference between the points is pretty low. Try an actual test print. It should have no problem compensating for that minor difference.
-
i had similar bed issues. very likely, your physical wiring or tubing connected to the print head bumps up against the corner wall or frame of your printer in this corner, and it slightly pushes the probe and print head downward, appearing like the bed is raised. Since it only happens in that corner, very extreme, it very likely is physical force on your toolhead.
-
undefined crowem has marked this topic as solved
