Machine just stopping with no displayed errors
-
Machine just stops with no displayed errors, running Duet2 board, no heater faults, nothing. This has happened a number of times recently running different jobs and in no specific spot each time, both extruders and bed heater just turns off.
I don't remember the gcode command to list errors or history, can someone help me?
-
@Cromker grab an output of M122 after it occurs and post it here
-
@jay_s_uk Hello, TKS for the reply. I was sitting near the machine when it happened again, this time I seen the error message : Over temp shutdown reported by drivers 3-4
-
@Cromker you're on a very old firmware. I would start by updating to 3.4.5
-
@Cromker said in Machine just stopping with no displayed errors:
Over temp shutdown reported by drivers 3-4
Are those drivers getting very hot to the touch?
Is the board actively fan cooled?
