Heatbed temperature
-
I have now resisted 100k
-
There is no B parameter in your M305 P0 command, so the firmware is using the default value of 3988. Do you have any information about the bed thermistor in your printer?
-
I have silicone mat, aluplatte, glass
M305 P0 T100000 B3988 R4700 H0 L0
is it right? -
resistance of thermistor has 103k
-
if it is the std Chinese type Silicon mat then they usually have a thermistor with a B Value of 3950 but this is at temps of 25/50 I used DC42's calculator and it gave a B value of 4008 for the typical temps of 100 degrees.
-
yes, silicone mat is from china
M305 P0 T100000 B4008 R4700 H0 L0it is OK?
-
Yes. However, increasing the beta value in M305 will reduce the temperature reading, for temperatures above 25C. So try B3950.
-
Now I have set 70 degrees and have 62.
can one adjust more exactly? -
Is that 62 measured with your IR thermometer? If so, then how accurate is your IR thermometer? They can often be quite a way out.
-
also bare in mind that with these Silicon heaters the thermistor is usually on the underside of it and is below the bed itself so you will get a difference anyhow but you can adjust the B Value to get it closer to what you want but As Ian (Deckingman) has pointed out do you know your IR Thermometer is accurate I would use a multi meter with a Thermocouple probe that is in very close contact with the top of the glass
