How do I install the 1HCL on the Duet3 Mini 5+?

[tylersuard]

Hello. The instructions in the documentation don't seem to apply to the mini. How do I set this up? There is no can-FD cable plug on the Mini board.

[Phaedrux]

Check again. Bottom left label.

[OwenD]

Had me worried for a minute
I've just ordered that combo
Must admit I was looking for an RJ45 RJ11 socket

[droftarts]

@tylersuard Thanks for pointing this out. I'll update the documentation with specific advice on making the connections when I get a chance, on this page: https://docs.duet3d.com/User_manual/Machine_configuration/CAN_connection

Ian

[tylersuard]

@OwenD Thank you Owen. I figured it out. I cut open the RJ11 cable, crimped the 2 middle wires (of 4) into a molex connector, and made sure I was matching L to L and H to H.