How are we supposed to clear the saved coordinates? (G60)
-
I find that if I print something large or move the bed far out of the way, next time I go to print, my bed will go back alllll the waaaayyy down before coming back up to start printing. I know it's because of the saved positions, but I can't think of anything other than moving to some small offset then manually (or scripted) re-issue G60 just so I store a closer position.
-
@gnydick When exactly is it "going all the way down", what command is being issued that causes it to do that? I don't think I've ever seen any of my printers do what you have described.
-
@gloomyandy It happens after I print a tall print. I have a lot of crash avoidance logic in my gcode that uses the G60 coords to make sure the bed is at a safe height during less determinant situations.
