Jog Speed on Web Interface

[flopes]

Hi guys
I changed the units on my laser cutter from mm to microns, once I am cutting very small parts.
The system behaves well when running g-codes. However when jogging from the web interface, I reach a speed limit of about 1000 microns per minute (do not know exactly). The speeds and accelerations are set to go much faster than that and on G-code they run just fine. How can I increase the maximum speed at jog interface?!

[flopes]

@flopes

[droftarts]

@flopes Feedrate for move buttons (mm/min) is in the Settings > Machine-Specific > General > Machine-Specific

Ian

[flopes]

@droftarts Thank you very much