@jay_s_uk Thank you very much

@droftarts Thank you very much

@flopes

Hi guys
I changed the units on my laser cutter from mm to microns, once I am cutting very small parts.
The system behaves well when running g-codes. However when jogging from the web interface, I reach a speed limit of about 1000 microns per minute (do not know exactly). The speeds and accelerations are set to go much faster than that and on G-code they run just fine. How can I increase the maximum speed at jog interface?!

@jay_s_uk thats awesome. impressive fast response. thank you

Hi
I have a laser cutter on duet2wifi, 3.4.5 firmware. It also has a panel Due connected.
It is machining very critical parts and the printer does drift in position over temperature. I would like to pause the cutter when the room is too hot or too cold and resume cutting when temperature is back to normal (controlling it at 26C +/- 0.3 degrees).
I can generate an error signal from the room temperature controller.
How do you advise me to connect duet2?
Thanks

@flopes or pwm?

@jay_s_uk Thanks
What about producing a 0-10V output, specified at tool definition?

I am making a small lathe and using a stepper motor as spindle. I am using the Duet2 wifi running Duet Web 3.4.6.
How can I control the rpm of the motor in such a way it stays spinning until commanded to stop?

Thanks

@jay_s_uk Should I put M203i only?

@jay_s_uk I set M203I0,
my limit is 0.5mm/min and not 0.5mm/s