CAN xt30 to mini5+ problem
-
I cannot get the crimped pins that came with the XT30 umbilical to insert into the housing for the 2 pin connector for the mini5+. I have tried many ways, even depressing the lock tab some, but no luck so far. These crimps look different than the ones that came with the board. Is there a different housing I am supposed to be using?
-
@jltx The two pin CAN connector on the Mini 5+ is 2.54mm Molex compatible. Use the crimps and shells that came with the Mini 5+, not the crimps that came with the toolboard.
See https://docs.duet3d.com/en/User_manual/Troubleshooting/Parts#connectors-used-on-main-and-on-most-expansion-boards for detailsIan