Dude about finish time…
-
Hi,
i have started a long…. very long print.
Its the body of Curiosity Rover... in Nasa Webpage....
i d'like know, when the printer finish, aprox. But i am nor sure when.
What time its the correct?
in this moment,DWI, say 20% completed, in aprox 3h.
P.D.: Forum loads VERYYYYY slow this evening???
-
The filament usage figure is typically the most accurate.
Before I start a long print, I use the simulation option (in Duet Web Control and in the current beta Panel Due firmware) to get an accurate print time.
-
hi,
i have try to simulate a print piece…. where is the time supposed print time? I can't see
I can read print duration 2:36, but this is the time to make simulation
-
The print time is reported in the GCode Console, and logged to SD card if you have logging enabled.
