Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    eSwitch mount for Duet Wifi (for Berd Air system)

    Scheduled Pinned Locked Moved
    Duet Hardware and wiring
    3
    4
    617
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Hergonowayundefined
      Hergonoway
      last edited by

      Hi,

      I wanted to share with you a design I've made to install the eSwitch board from Makerhive onto the Duet Wifi. I've search a way to carry the board on my printer while installing the Berd Air system, I finally ended up by designing this mount.

      It plugs in an IDC connector and was designed to coexist with a PT100 daughter board 🙂

      Here's the link : https://www.thingiverse.com/thing:2879778

      Hope it'll help few guys around here.

      Delta goes BrrrRRRRrrrrrRRRRrrr

      1 Reply Last reply Reply Quote 0
      • timcurtis67undefined
        timcurtis67
        last edited by

        Sweet! Thank you. I'll print one up and try it out.

        1 Reply Last reply Reply Quote 0
        • uk25undefined
          uk25
          last edited by

          Very clever design, thanks!

          1 Reply Last reply Reply Quote 0
          • Hergonowayundefined
            Hergonoway
            last edited by

            Note : If you make terrible bridges just add support, but only for the bottom plane, groove slots are made with a 45 degrees angle so no bridge are required since it's not an extrem overhang.

            Delta goes BrrrRRRRrrrrrRRRRrrr

            1 Reply Last reply Reply Quote 0
            • First post
              Last post
            Unless otherwise noted, all forum content is licensed under CC-BY-SA