Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Resume bed heating

    Scheduled Pinned Locked Moved
    General Discussion
    5
    8
    1.1k
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • denkeundefined
      denke
      last edited by

      Dear All!

      Is there a way to continue bed heating after setting it to standby with M144, or to off by M140 S-273.15?

      The reprap gcode base states that M140 without parameters should just do that, but it does not seem to work, it rather reports the current bed temp.

      1 Reply Last reply Reply Quote 0
      • dc42undefined
        dc42 administrators
        last edited by

        Looks like there isn't currently a way to resume bed heating without specifying the target temperature. I think the most logical way to resolve this would be to add a parameter to M144 to say whether you want to put the bed heater in standby mode or in active mode, with the default being standby for backwards compatibility.

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        timcurtis67undefined denkeundefined 2 Replies Last reply Reply Quote 0
        • timcurtis67undefined
          timcurtis67 @dc42
          last edited by

          @dc42 said in Resume bed heating:

          Looks like there isn't currently a way to resume bed heating without specifying the target temperature. I think the most logical way to resolve this would be to add a parameter to M144 to say whether you want to put the bed heater in standby mode or in active mode, with the default being standby for backwards compatibility.

          +1

          1 Reply Last reply Reply Quote 0
          • denkeundefined
            denke @dc42
            last edited by

            @dc42 Thanks, it sounds very good!

            1 Reply Last reply Reply Quote 0
            • Scoobyvroomundefined
              Scoobyvroom
              last edited by

              @dc42 I registered an account to look/ask this same question. I don't really want my filament sensor triggered pause to sit for hours with the bed and extruder at temp. I wish this would be an option such as M109 R2. I am very new to the Duet. I know Sbase has this as an option to shut off heaters during a pause in the config file. I am kind of surprised the duet doesn't have something like this.

              Thanks for all you you do DC42!

              1 Reply Last reply Reply Quote 0
              • Phaedruxundefined
                Phaedrux Moderator
                last edited by

                I could see wanting to keep the heater active during a pause to prevent the print from detaching. What's less efficient, keeping the bed warm or toss a failed print?

                Z-Bot CoreXY Build | Thingiverse Profile

                1 Reply Last reply Reply Quote 0
                • dc42undefined
                  dc42 administrators
                  last edited by

                  M144 S1 will set the bed heater back to active in the next firmware release candidate.

                  Duet WiFi hardware designer and firmware engineer
                  Please do not ask me for Duet support via PM or email, use the forum
                  http://www.escher3d.com, https://miscsolutions.wordpress.com

                  1 Reply Last reply Reply Quote 0
                  • denkeundefined
                    denke
                    last edited by

                    Tested, it works. Thanks DC!

                    1 Reply Last reply Reply Quote 0
                    • First post
                      Last post
                    Unless otherwise noted, all forum content is licensed under CC-BY-SA