• Tags
  • Documentation
  • Order
  • Register
  • Login
Duet3D Logo Duet3D
  • Tags
  • Documentation
  • Order
  • Register
  • Login

Extruder Won't Load

Scheduled Pinned Locked Moved
Duet Hardware and wiring
extruder motor
3
5
850
Loading More Posts
  • Oldest to Newest
  • Newest to Oldest
  • Most Votes
Reply
  • Reply as topic
Log in to reply
This topic has been deleted. Only users with topic management privileges can see it.
  • undefined
    bellwether
    last edited by 8 Jun 2018, 03:51

    The error message says that the hot end is not hot enough. But according the web control panel, it is hot enough. What g-code could be confusing the extruder?

    1 Reply Last reply Reply Quote 0
    • undefined
      Dr_Ju_Ju
      last edited by 8 Jun 2018, 04:48

      Is your hotend actually defined as part of your tool ? my Tool0 setting is; M563 P0 D0 H1 F0 F1

      So check that it is properly defined. and when it has reached temperature, check that you can extrude by using the presets in the Duet web interface.

      Julian,

      Old goat, learning new things….

      1 Reply Last reply Reply Quote 0
      • undefined
        bellwether
        last edited by bellwether 6 Aug 2018, 21:19 8 Jun 2018, 20:41

        yes it is
        the temperature shows up on the DWC associated with tool 0,

        here is the code in the config file
        M563 P0 D0 H1 F0 F1 ; tool 0 uses extruder drive 0 and heater 1
        G10 P0 R0 S0 ; Set initial tool 0 active and standby temperatures to 0C

        one more thing the unload will work but the load will not without the error about temperature

        1 Reply Last reply Reply Quote 0
        • undefined
          dc42 administrators
          last edited by 9 Jun 2018, 07:59

          What temperature are you heating the hot end to? RRF requires a minimum of 160C to extrude and 90C to retract.

          You can use the M302 command to enable cold extrusion.

          Duet WiFi hardware designer and firmware engineer
          Please do not ask me for Duet support via PM or email, use the forum
          http://www.escher3d.com, https://miscsolutions.wordpress.com

          1 Reply Last reply Reply Quote 0
          • undefined
            bellwether
            last edited by 10 Jun 2018, 21:44

            Yup, using only 120, increased it to 220, all is well, thanks

            1 Reply Last reply Reply Quote 0
            4 out of 5
            • First post
              4/5
              Last post
            Unless otherwise noted, all forum content is licensed under CC-BY-SA