My Duet Wifi first time connection, brings a Heater 1 - Fault.
-
-
Be sure you activate Tool Zero. One easy way is a
T0
At the end of the config.g
And, generally check things around your tool and heater configuration...
-
@danal
I have nothing hooked up. I just connected the board via wifi for the first time and I hope it is not a fault with the board.. I jsut connected it to the PC via the usb and set up the wireless network. Nothing else... -
@mendelevium you heaters reads 2000C (probably because no thermistor is connected). That is why it marks you heater as fault.
-
Could you upload your config.g or wherever you have your heater config stored? I think I was having this same issue...
-
@mendelevium said in My Duet Wifi first time connection, brings a Heater 1 - Fault.:
@danal
I have nothing hooked up. I just connected the board via wifi for the first time and I hope it is not a fault with the board.. I jsut connected it to the PC via the usb and set up the wireless network. Nothing else...Got it.
Having no thermistor connected, a fault is CORRECT behavior, the board is saying that sensor has an impossible reading. Even when not heating, it should sense "room temperature".
All good.