New PanelDue firmware 1.15 beta 2

jamesarm97 · 11 Sept 2016, 13:16

Ok. Thanks. Is that just in case a bed thermistor isn't connected it won't think it needs to raise the bed temp to 0 and causes it to heat?

dc42 · 11 Sept 2016, 15:43

I don't think there is a particular reason for it. The hot end temperature Is the same, however most people put G10 commands in config.g to set the temperatures to zero.

Dougal1957 · 13 Sept 2016, 13:48

David

Don't know if this is a bug at all but on my V1.0 PanelDUE Controller and 4.3 inch screen running 1.15B3 I no longer get the Gcode file list so can't print from it?

DWC Work's fine and all other FW is upto Date FW 1.15c Wifi at 1.02 and DWC 1.12.

Any ideas? Think I may roll back to 1.14 on the Panel in stages to see what happens?

Doug

Doh feel like a complete wally now just re-read the change log and see you've moved the SD Card to control Page!!

I was looking on the Print page for it Doh.

dc42 · 13 Sept 2016, 15:50

Yes, I decided it made more sense on the control page - because all the other commands I use just before starting a print are also there.

Zesty_Lykle · 17 Sept 2016, 07:50

I cannot update my PanelDue because I cannot get the BOSSAC installed. It starts to install and then gives an error.
In this case I will revert to the definition of insanity, and try it again. For the 5th time.

Nope. Setup wizard ended prematurely.

T3P3Tony · 17 Sept 2016, 09:12

Lykle what OS are you using?

Zesty_Lykle · 17 Sept 2016, 10:28

Sorry, of course.
I am running Win10 on a laptop.

dc42 · 17 Sept 2016, 16:22

You don't need to install bossac if you just copy the bossac.exe file from the Tools folder of my GitHub repo.

DjDemonD · 17 Sept 2016, 19:15

I installed it using sam-ba v2.16 as I had some familiarity with this having using it to recover the duet wifi. Seems straightforward enough.

Zesty_Lykle · 18 Sept 2016, 14:25

Found it, done it and updated the firmware.
Thanks guys. Great support.

My PanelDue is now running 1.15beta3.