Configuration for custom filament multiplexer

fma

Ok! So I can use whatever axis I want (UVWABC)?

dc42

@fma said in Configuration for custom filament multiplexer:

Ok! So I can use whatever axis I want (UVWABC)?

Yes.

fma

Ok, my first tests show that I have too much friction in my filament loading system, even with the clutch disengaged.

A solution I would like to test is use the loading motor to help pushing the filament. Is there a way to duplicate a geometry axis to an extruder axis?

dc42

You can use M584 to assign an extruder drive number as well as an axis to the stepper driver during loading.

fma

I tried to change:

M584 X0 Y1 Z2 U6 E5

to:

M584 X0 Y1 Z2 E5:6

and all other config sections referring to U, but it does not work: when I extrude, axis 6 does not turn. What do I miss?

dc42

To extrude using more than one extruder, the current tool must be configured to use both extruders. Then you must either set the mix ratio, or you must use multiple E values in the G1 command, e.g. G1 E10:10.

fma

Got it! I enabled mixing ratio, and it works fine.

Thanks.

fma

The strange thing is I can't reach the same speed when I drive both motors (either with E10:10 or with mixing ratio) than when I drive one or the other...

My config is:

M584 X0 Y1 Z2 E5:6          ; Remap axes
M350 X16 Y16 Z16 E16:16 I1  ; Configure microstepping with interpolation

M92 X66.667 Y66.667 Z1417.323 E530:128  ; Set steps per mm
M203 X30000 Y30000 Z1200 E3600:3600     ; Set maximum speeds (mm/min)
M201 X1000 Y1000 Z100 E3000:3000        ; Set accelerations (mm/s^2)
M566 X900 Y900 Z60 E600:600             ; Set maximum instantaneous speed changes (mm/min)
M906 X1750 Y1750 Z1750 E750:1300 I30    ; Set motor currents (mA) and motor idle factor in per cent

M563 P0 D0:1 H3 F2  ; Define tool 0 using Drive 0, Heater 3 and Fan 2
M568 P0 S1          ; Enable mixing for tool 0
M567 P0 E1:1        : Set mixing ratio for tool 0

Any idea why?

dc42

I think you will need to double the F parameter in the G1 command if it is an extrusion-only move, because F is assumed to give the total extrusion rate required.

fma

Ok, I understand. I will change the steps/mm instead.