Ft-5/Duet wifi/Cura Prints not homing properly, Help!
-
Are you printing from the DWC by uploading the gcode to the SD card or are you printing via usb?
How do you have the bed setup in Cura?
-
-
@starpowersolaryahoo-com not sure if this will help you but you may want to change to reprapfirmware gcode flavour
-
Aaa...nd reading that I just realized I forgot to comment out the first M305 when I put in a PT1000
-
@phaedrux It made no difference, same result. Im dead in the water here.
-
@stewwy We have different machines, but Ill try your settings. Thx
-
See my additional questions from a few posts up.
-
When sending a print, the XY motors start moving and skipping steps, then the they move to the wrong location and begin printing. Ive included a link to a youtube video that shows their behavior, https://youtu.be/uHj62Tgl_jw. Anyone have any idea of whats going on? Again the printer homes correctly but reacts like this when attempting to print.
-
It looks like you have the origin set to the rear right of the printer, which is opposite of what it normally is.
Check this out and see if it makes sense.
https://drmrehorst.blogspot.com/2017/08/setting-up-3d-printers-origin.html
-
Phaedrux, that did the trick! I studied the info you linked and learned how printers and slicers align the bed and everything on it. I incorporated the knowledge and it made all the difference. A million thanks!
