inductive probe
-
I have an NPN probe I'm replacing my bltouch clone with.
The clone works 95% of the time, this means mesh compensation is a bit hit and miss, literally.
A quick question, can I pick up the 12v from the permanently on fan connection. I can't see any reason why not but better safe than sorry , which is why I'm asking.
Thanks in advance
-
@stewwy said in inductive probe:
A quick question, can I pick up the 12v from the permanently on fan connection.
Yes, you can.
-
Great subject, thanks! Would that also work with a 24V power supply using VIN for the fans and a SN04-N?
The SN04-N has the following markings:
BN-10~30V
BK-NPN-NO
BU-0V -
Well it worked for me, thanks
@TLeTourneau don't forget the diode on the signal lead
-
@stewwy thanks! I am just trying to find a source where I don't have to get a 50 pack of them.
-
got mine for £2 for 5 x bat42 from ebay and they are always useful for this sort of thing
-
Would a 1N5818 Schottky work?
-
The diode isn't needed if you have a version 1.04 Duet, but make sure you connect the sensor output to the correct pin of the Z probe connector (the one labelled IN).
And a 1N5818 would work.
-
@dc42 Thanks! I've connected the probe with the output (black wire) going to the Z Probe In, the negative (blue wire) going to the ground connection on the Z probe header and the positive (brown wire) going to the positive on an always on fan header. I have a V1.04 board so I did not use the Schottky although the BAT43's did arrive today :). The probe light comes on when the bed is near, now I just need to work out the configuration based on the information in the wiki. Thanks again for the help!
-
In the M558 command in config.g use either P8 or P5, and also use I1.