Behavior issue: STOP @PanelDue vs Emergency Stop @DWC [SOLVED]
-
When I press the "Emergency Stop" button at DWC it behaves as I would like: it stops anything and restarts the board. But when I press the "STOP" button at PanelDue it generally does not stop or waits for some last gcode (like a M116) to finish.
-
Not sure, but seems like DWC "Emergency Stop" sends M112, when PanelDue "STOP" sends M0. Just guessing...
-
@brunofporto said in Behavior issue: STOP @ PanelDue vs Emergency Stop @ DWC:
When I press the "Emergency Stop" button at DWC it behaves as I would like: it stops anything and restarts the board. But when I press the "STOP" button at PanelDue it generally does not stop or waits for some last gcode (like a M116) to finish.
The latest PanelDue firmware used together with RRF 2.02RC3 normally give an instant stop.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com -
@dc42 Thank you. I am not with the latest PanelDue firmware yet. I'll test it asap.
