Question about M106

dc42

The resolution depends on the PWM frequency you have set. It's usually well below 1%.

What commands are you sending to adjust the PWM?

fcwilt

The resolution depends on the PWM frequency you have set. It's usually well below 1%.

What commands are you sending to adjust the PWM?

According to the docs the FAN outputs on the Duex5 v0.7 do not have adjustable frequency.

To test M106 I have tried:

M106 P6 S0.0 - LEDs are off - DWC slider = 0%
M106 P6 S0.5 - LEDS are medium - DWC slider is 50%
M106 P6 S1.0 - LEDS are max - DWC slider is 100%

M106 P6 0 - LEDs are off - DWC slider is 0%
M106 P6 2 - LEDS are max - DWC slider is 100%
M106 P6 255 - LEDS are max - DWC slider is 100%

Frederick

dc42

OK, you are using fans on the DueX board. I'll re-test those, because I only tested direct-connect fans in my recent tests.

dc42

I found there is a problem using values in the range 2-255 if you have other parameters in the M106 command. For example, M101 P6 S128 sets the fan to half PWM; but M106 P6 S128 F100 sets it to full PWM. I will fix this in the next 2.02RC.

fcwilt

@dc42 said in Question about M106:

I found there is a problem using values in the range 2-255 if you have other parameters in the M106 command. For example, M101 P6 S128 sets the fan to half PWM; but M106 P6 S128 F100 sets it to full PWM. I will fix this in the next 2.02RC.

Thanks for the feedback.

But what you found does not match what I found, at least with it comes to a Duex5 v0.7.

No extra parameters had to be present for the S1 through S254 values to cause the setting (according to the DWC slider) to be 100%.

Frederick

dc42

@fcwilt said in Question about M106:

No extra parameters had to be present for the S1 through S254 values to cause the setting (according to the DWC slider) to be 100%.

I was unable to reproduce that, it worked perfectly for me provided that the only parameters to the M106 command were P and S.

fcwilt

@dc42 said in Question about M106:

@fcwilt said in Question about M106:

No extra parameters had to be present for the S1 through S254 values to cause the setting (according to the DWC slider) to be 100%.

I was unable to reproduce that, it worked perfectly for me provided that the only parameters to the M106 command were P and S.

I will check it again.

Frederick

fcwilt

@dc42 said in Question about M106:

@fcwilt said in Question about M106:

No extra parameters had to be present for the S1 through S254 values to cause the setting (according to the DWC slider) to be 100%.

I was unable to reproduce that, it worked perfectly for me provided that the only parameters to the M106 command were P and S.

Well I went back and tested it and it now works - values from 1 to 255 have the expected effect.

Under any conditions does the firmware "remember" that extra parameters were used at one point and apply them for subsequent commands that have only P and S?

Frederick

dc42

No, it doesn't.

fcwilt

@dc42 said in Question about M106:

No, it doesn't.

Then I will just have to keep an eye on the problem and see if it reappears and under what circumstances.

Thanks.

Frederick