Anycubic kossel bed leveling.

[ohluckyirish]

I ran the bed leveling and mesh leveling with the probe 2 from anycubic. I started a calibration cube print and the printer changes height when moving from one corner of the print to the other.

[DocTrucker]

Which i what it would need to do if the bed was not level.

You can see the results of bed levelling in the duet web control webpage.

[ohluckyirish]

https://youtu.be/b61JP3W8hKU

[DocTrucker]

Right that makes more sense now! I was looking at the Any Cubic Linear Plus over yuletide and noticed the company gave different lengths for it's arms. Have you pulled the values like radius, arm length, and probe offset from another person running this machine with a Duet?

[Veti]

that is extreme. did you do an auto calibration when setting up the printer?

[ohluckyirish]

@doctrucker yes I pulled the values from another person.

[dc42]

@ohluckyirish said in Anycubic kossel bed leveling.:

@doctrucker yes I pulled the values from another person.

That's not the same as doing autocalibration. See https://duet3d.dozuki.com/Wiki/Calibrating_a_delta_printer#Section_Auto_calibration.

[DocTrucker]

@dc42 We were discussing rod lengths, radius etc. Does auto calibration not need to know these values?

Any Cubic seemed to have two different sets of what they said these values were in firmware that I downloaded. maybe subtle differences in machines that I was not aware of.

[Veti]

anycubic released different stages of development under the same name. so you do need to verify your values.