Im having this issue when i start any print.
i have already ran the auto calibration and updated the M665 & M666 per this link https://duet3d.dozuki.com/Wiki/ConfiguringRepRapFirmwareDeltaPrinter?fbclid=IwAR0FyapfQXN1LNuSmc9Pz63V_2w1EMoH-yCCYjtpPaU_yiQyteWJjl1-Y3M
here is a video showing the issue
https://www.facebook.com/michael.mcnair.7792/videos/2141336582579449/
can someone help me with configuring a anycubic kossel plus with the duet board. i have everything hooked up and is running but im having the issue with bed leveling and im unsure what my parameters should be for this printer. (Rod length, delta radius, printable radius, maximum carriage travel, homed height, minimum z.) what should the microstepping be?
im using the Z-probe that came with the printer. what should the trigger height be and trigger value.
what should the Bed probing for delta calibration be set to. (Compensation)
im using the RepRapFirmware confiuration tool. but a lot it is asking im not sure about.
@doctrucker yes I pulled the values from another person.
I ran the bed leveling and mesh leveling with the probe 2 from anycubic. I started a calibration cube print and the printer changes height when moving from one corner of the print to the other.
okay i got it i needed to add a jumper to both the v fan and int 5v. im so afraid of damaging the board i have already damaged two gorilla boards on my anycubic kossel.
i moved the jumper from the int 5v en to the v fan jumper fan select. now only the fan comes on and none of the green lights on the board come on
is there only post to be one jumper in ?
the part cooling fan came on that is plugged into the always fan port, but none of the green lights come on ?
