Tevo Little Monster setup with Duet WiFi
-
Hello all, I've had a TLM & DW for over 8 months sitting in their boxes and now I'm getting around to the build, better late than never. My question is about calibration: After home all axis G28, I notice that the X carriage is higher to the top of the tower by about 3mm. Does this not cause the effector to tilt ? How do I fix this. I tried adjusting the endstop trigger screw to no avail.
-
Do you mean that the endstop is triggering 3mm higher for the X tower than for the Y and Z towers? If so:
-
Make sure the motion really does stop when the correct endstop triggers, in case you have the endstop wires mixed up.
-
If possible, use the endstop adjusting screws (if there is one) or adjust the endstop switch position so that the endstop trigger within about 1mm of each other.
-
If that's not easy to do, don't worry. When you run auto calibration, the M666 endstop offset parameters will be adjusted to account for the different trigger heights.
-
-
Thank you for clearing that up. I tried the best that can be done with the screws, so I'm depending on Auto-Calibration to do the rest...
