You are correct again.....thanks

During a G32 bed leveling session I had a BLT deployment issue (Z height) which left an error condition on the probe. I have an "M280 P3 S160 I1" in my deployprobe.g to clear such a condition prior to probe deployment. So when I restart the process via G32, bed.g calls the deployprobe.g macro, which in my case should clear BLTouch errors. This is not working, what am I doing wrong ???
0_1550691836795_bed.g
0_1550691846982_deployprobe.g

Thank you for clearing that up. I tried the best that can be done with the screws, so I'm depending on Auto-Calibration to do the rest...

Hello all, I've had a TLM & DW for over 8 months sitting in their boxes and now I'm getting around to the build, better late than never. My question is about calibration: After home all axis G28, I notice that the X carriage is higher to the top of the tower by about 3mm. Does this not cause the effector to tilt ? How do I fix this. I tried adjusting the endstop trigger screw to no avail.

0_1550540401072_config.g