Time estimates are of
-
Hi there,
I noticed that the time estimates inside DWC and the LCD screen are totally off.
Never seen this and it has always been pretty much the same in the past, but this time it's just waaaay of.Any reasons why this is?
Is this normal?
Firmware stuff:
-
That is indeed odd. Which one is closest to being correct?
-
@dc42 The one in DWC seems to be correct.
-
Is the PanelDue still updating? Or could the display be frozen from a previous print? If it's frozen, try pressing the Reset button on PanelDue.
-
@dc42 Just as you wrote that I was thinking the same.
Paneldue is still responsive however it doesn't seem to update.
Checking the console I'm seeing this:
-
You may have a bad connection in the Dout wire from PanelDue to URXD on the Duet.
-
Since it's printing right now I will not do anything with it. But how would I have to check if I have a bad connection?
-
If it is a bad connection, it will probably fail completely, or may have already done so.
-
@dc42 I'll check it once I get home from work.
Does this fall under warranty btw? -
@r3play said in Time estimates are of:
@dc42 I'll check it once I get home from work.
Does this fall under warranty btw?What cable are you using between the PanelDue and the Duet?
-
@dc42
The 4 wire cable.
Btw: Just turned my printer back on, didn't change anything or didn't look yet.
But the Paneldue reacts now when I turn on a heater or so..
