"Z probe already triggered at the start of the homing move."????
-
@phaedrux That is correct. Nothing. Tried it several time after several restarts
-
Here is deployprobe.g
M280 P3 S10
and retractprobe.g
M280 P3 S90
-
Try adding
I1to those. -
Ok, is that a pipe or I
-
I tried
M280 P3 S10|1
no joy
-
it's the letter i, for invert.
M280 P3 S10 I1
M280 P3 S90 I1 -
When I ordered a replacement BLT because of the broken wire, I did not mount it on the printer, but rather just attached and tested the new wire on the old BLT. If I don't get anywhere today on this, I may try switching to the new probe as well. I hate doing that unless I am pretty sure thats where the fault lies
-
I'm quite sure that adding the inversion flag will solve your problem.
-
Oh wow!!!! It deloyed with M401 and retracted with M402. I tried the I1 and the |1 both and neither would work, but I was not putting a space before them because that is what I thought I saw elsewhere. At any event, it worked. Now I need to back and walk through the testing again.
-
Wish I could buy you a cup of coffee, but I suspect you are on the other side of the pond.
Thank you very much!!
-
@crchisholm said in "Z probe already triggered at the start of the homing move."????:
I suspect you are on the other side of the pond.
Correct. Trapped in a month long polar vortex.
Glad it's working now.
-
Ouch. Then I guess I shouldn't mention the t-shirt and shorts whether we've been having recently. Opps. To late.
