Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Handling error codes to switch off power using M81

    Scheduled Pinned Locked Moved
    General Discussion
    2
    3
    432
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • jer1001undefined
      jer1001
      last edited by

      I am trying to understand if there are any settings to get the duet to switch off the 24V power supply using the M81 command. As far as I can see the heaters are turned off if it detects an issue, but it does not turn off the power supply. I can switch the power on and off no issues and this is handy at the end of printing. However I am not sure about how error messages can be arranged to power down the 24 volt power supply.

      Many thanks

      Jeremy

      1 Reply Last reply Reply Quote 0
      • AndreSundefined
        AndreS
        last edited by

        I think it is not possible at the moment, but will be possible with the introduction of conditional execution of gcode in some of the next firmware releases.

        1 Reply Last reply Reply Quote 1
        • jer1001undefined
          jer1001
          last edited by

          Hi Andre
          Thanks for your help, makes sense.
          Jeremy

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA