Endstop Problems Duet3D WIFI
-
hello,
now i have a small prob. with the wirering of those mechanikal Endstop.i have read the "https://duet3d.dozuki.com/Wiki/Connecting_endstop_switches#Section_Duet_endstop_inputs"
but i´m not sure which one are the right.
if i conect the endstop like on the picture the Duet Bord don´t boot and the paneldue has no config.
If i press both endstops at the same time, the board boot and connect to wifi and works
-
update !!!
i think i can see a LED
it´s now wirering like a Makerbot Mechanical Endstop
-
Try connecting the red wire to the centre pin on the Duet endstop connector, the white wire to the STP pin, and the black wire to the GND pin.
