Delta set up

[Dugee]

I am converting a mini delta to Duet2 Maestro. I had the printer running well with the original board.

Would I be better to use my calibration settings from my previous set up at initial set up of the board or should I just start from stock figures and use auto calibration to get it dialled in?

I'm a little bit out of my comfort zone doing this but looking forward to the challenge!

[Veti]

yes use your previous setting for the initial set up then use auto calibration.

use the configurator to help you
https://configurator.reprapfirmware.org/

[dc42]

Start with your current settings, but bear in mind that all speeds in RRF are in mm/min whereas Marlin uses a mixture of mm/sec and mm/min.

[Dugee]

@dc42 Thanks for the reminder. I had seen that in the documentation but I'll make a note when I start the install.