Short-to-ground on drivers - Please help

[Veti]

are you sure the specs are correct? 2.4Ohm vs 1.5Ohm

if you are sure that it is correct. adjust the motor current to 85% or the rated current(1.7A). you currently run them at 800mA

[YanivK]

I tested then on the wire end. without the wire it's 1.9-2.0 ohm

I am trying to understand what file do i need for the firmware update: is it Duet2Firmware-2.03.zip or Duet2CombinedFirmware.bin ?

Thanks for the help

[Veti]

see
https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware

you will need to update the wifi firmware and the dwc as well.

[YanivK]

All updates are done!

Current is now 1.4A

Nothing changed

Any other direction ?

Thanks again, Yaniv

[Veti]

does the messages appear as soon as you move anything. or sometime in between?
does it repeat?

[YanivK]

The messages appear as soon as i move X or Y and it repeats forever (every 5 seconds)

[Veti]

possibilities.

• you damaged the driver by having a short circuit in your stepper motor wiring.
• drivers failed during the first few hours of use for no apparent reason. (unlikely to happen to all drivers at the same time)
• your wiring is incorrect. bad crimp. phases not connected correctly.

maybe dc42 can weigh in on this.

[YanivK]

Same motors with the same wiring works on driver 2,
I connected the Z motor (the one that always worked) to E2 just to check and it had the same behavior from the first try.
This is the first time i use the board not hours, seconds...

Thanks, Yaniv

[dc42]

Something clearly isn't right. Please ask your supplier to replace your Duet. If it's a genuine UK-manufactured one, https://www.duet3d.com/warranty.

[YanivK]

It is "genuine UK-manufactured" got it from E3D

Thanks you, Yaniv